AudioCodes Mediant 2600 - Page 388

User's Manual 388 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description

[3] SUBSCRIBE = Only SIP SUBSCRIBE messages.
 [4] INVITE and REGISTER = All SIP messages except
SUBSCRIBE.
 [5] INVITE and SUBSCRIBE = All SIP messages except
REGISTER.
ReRoute IP Group ID
CLI: re-route-ip-group-id
[IPOutboundManipulation_ReRo
uteIPGroupID]
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This parameter is
typically used for re-routing requests (e.g., INVITEs) when
interworking is required for SIP 3xx redirect responses or
REFER messages.
The default is -1 (i.e., not configured).
Notes:
 This parameter functions together with the 'Call Trigger'
parameter (see below).
 For more information on interworking of SIP 3xx redirect
responses or REFER messages, see ''Interworking SIP 3xx
Redirect Responses'' on page 337 and ''Interworking SIP
REFER Messages'' on page 340, respectively.
Call Trigger
CLI: trigger
[IPOutboundManipulation_Trigg
er]
Defines the reason (i.e, trigger) for the re-routing of the SIP
request:
 [0] Any = (Default) Re-routed for all scenarios (re-routes and
non-re-routes).
 [1] 3xx = Re-routed if it triggered as a result of a SIP 3xx
response.
 [2] REFER = Re-routed if it triggered as a result of a REFER
request.
 [3] 3xx or REFER = Applies to options [1] and [2].
 [4] Initial only = Regular requests that the device forwards to
a destination. In other words, re-routing of requests triggered
by the receipt of REFER or 3xx does not apply.
Operation Manipulation Rule - Action
Manipulated Item
CLI: manipulated-uri
[IPOutboundManipulation_IsAdd
itionalManipulation]
Defines the element in the SIP message that you want
manipulated.
 [0] Source URI = (Default) Manipulates the source SIP
Request-URI user part.
 [1] Destination URI = Manipulates the destination SIP
Request-URI user part.
 [2] Calling Name = Manipulates the calling name in the SIP
message.
Remove From Left
CLI: remove-from-left
[IPOutboundManipulation_Remo
veFromLeft]
Defines the number of digits to remove from the left of the
manipulated item prefix. For example, if you enter 3 and the
user name is "john", the new user name is "n".
Remove From Right
CLI: remove-from-right
[IPOutboundManipulation_Remo
veFromRight]
Defines the number of digits to remove from the right of the
manipulated item prefix. For example, if you enter 3 and the
user name is "john", the new user name is "j".