AudioCodes Mediant 4000 SBC - RADIUS-Based Services; Enabling RADIUS Services

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
Parameter Value
Condition Var.Session.0 regex (.*),(.*),(.*)
Action Subject Header.My-header2
Action Type Add
Action Value $2
Row Rule Use Previous Condition
Index 3
Name Send My-header3 to SRS
Manipulation Set ID 12
Message Type Invite.Request
Condition Var.Session.0 regex (.*),(.*),(.*)
Action Subject Header.My-header3
Action Type Add
Action Value $3
Row Rule Use Previous Condition
b. Assign the above manipulation rules to the relevant IP Groups:
◆ In the IP Group of the recorded call leg which sends this header, configure the
'Inbound Message Manipulation Set' parameter to 11 (i.e., rule configured in Index 0).
◆ In the IP Group of the SRS, configure the 'Outbound Message Manipulation Set'
parameter to 12 (i.e., rules configured in Index 1, 2 and 3).
RADIUS-based Services
The device supports Remote Authentication Dial In User Service (RADIUS) by acting as a
RADIUS client. You can use RADIUS for the following:
■ Authentication and authorization of management users (login username and password) to gain
access to the device's management interface.
■ Accounting where the device sends accounting data of SIP calls as call detail records (CDR)
to a RADIUS Accounting server (for third-party billing purposes).
Enabling RADIUS Services
Before you can implement any RADIUS services, you must enable the RADIUS feature, as
described in the procedure below.
➢ To enable RADIUS:
1. Open the Authentication Server page (Setup menu > Administration tab > Web & CLI folder
> Authentication Server).
- 207 -