AudioCodes Mediant 4000 SBC - Configuring User Information; Enabling the User Information Table; Configuring SBC User Information

CHAPTER20 SIP Definitions
Mediant 4000 SBC | User's Manual
uri=”10.2.2.222”,
response=“b9c45d0234a5abf5ddf5c704029b38cf”
7. Upon receiving this request and if accepted by the Proxy, the Proxy returns a 200 OK
response, completing the registration transaction:
SIP/2.0 200 OK
Via: SIP/2.0/UDP 10.1.1.200
From: <sip: 122@10.1.1.200>;tag=1c23940
To: <sip: 122@10.1.1.200>
Call-ID: 654982194@10.1.1.200
Cseq: 1 REGISTER
Date: Thu, 26 Jul 2012 09:34:42 GMT
Server: Columbia-SIP-Server/1.17
Content-Length: 0
Contact: <sip:122@10.1.1.200>; expires="Thu, 26 Jul 2012 10:34:42 GMT";
action=proxy; q=1.00
Contact: <122@10.1.1.200:>; expires="Tue, 19 Jan 2038 03:14:07 GMT";
action=proxy; q=0.00
Expires: Thu, 26 Jul 2012 10:34:42 GMT
Configuring User Information
This section describes User Information configuration.
Enabling the User Information Table
Before you can use the User Information table, you need to enable the User Information
functionality.
➢ To enable User Information functionality:
1. Make sure that your device's License Key includes the far-end user license ("Far End Users"),
which specifies the maximum number of supported users. To view the License Key, see
Viewing the License Key.
2. Open the Proxy & Registration page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Proxy & Registration).
3. From the 'User-Information Usage' drop-down list [EnableUserInfoUsage], select Enable:
4. Reset the device with a save-to-flash for your settings to take effect; the User Information
table now becomes available in the Web interface.
Configuring SBC User Information
The User Information table lets you configure up to or 20,000 SBC users. You can use the table for
the following:
- 447 -