AudioCodes Mediant 4000 SBC - Serial Parameters

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
'Trap Community String'
configure system > snmp trap >
community-string
[SNMPTrapCommunityStringPassword]
Defines the community string for SNMP
traps. For more information, see Configuring
SNMP Community Strings on page62.
Serial Parameters
The serial interface parameters are described in the table below.
Table 60-6: Serial Parameters
Parameter Description
[DisableRS232] Enables the device's RS-232 (serial) port.
■ [0] = Enabled
■ [1] = (Default) Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. To establish serial
communication with the device, see Establishing a CLI Session.
Note: For the parameter to take effect, a device reset is required.
[SerialBaudRate] Defines the serial communication baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For the parameter to take effect, a device reset is required.
[SerialData] Defines the serial communication data bit.
■ [7] = 7-bit
■ [8] = (Default) 8-bit
Note: For the parameter to take effect, a device reset is required.
[SerialParity] Defines the serial communication polarity.
■ [0] = (Default) None
■ [1] = Odd
■ [2] = Even
Note: For the parameter to take effect, a device reset is required.
[SerialStop] Defines the serial communication stop bit.
■ [1] = (Default) 1-bit (default)
■ [2] = 2-bit
Note: For the parameter to take effect, a device reset is required.
[SerialFlowControl] Defines the serial communication flow control.
■ [0] = (Default) None
■ [1] = Hardware
Note: For the parameter to take effect, a device reset is required.
- 874 -