AudioCodes Mediant 4000 SBC - Proxy, Registration and Authentication Parameters

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
[OCSPDefaultResponse] ■ [0] Reject (default)
■ [1] Allow
Proxy, Registration and Authentication Parameters
The proxy server, registration and authentication SIP parameters are described in the table below.
Table 60-28:Proxy, Registration and Authentication SIP Parameters
Parameter Description
'Proxy Name'
configure voip > sip-
definition proxy-and-
registration > proxy-name
[ProxyName]
Defines the Home Proxy domain name. If specified,
this name is used as the Request-URI in REGISTER,
INVITE and other SIP messages, and as the host part
of the To header in INVITE messages. If not specified,
the Proxy IP address is used instead.
The valid value is a string of up to 49 characters.
Note: The parameter functions together with the
UseProxyIPasHost parameter.
'Use Proxy IP as Host'
configure voip > sip-
definition proxy-and-
registration > use-proxy-
ip-as-host
[UseProxyIPasHost]
Enables the use of the proxy server's IP address (in
dotted-decimal notation) as the host name in SIP From
and To headers in REGISTER requests.
■ [0] Disable (default)
■ [1] Enable
If the parameter is disabled and the device registers to
an IP Group (i.e., proxy server), it uses the string
configured by the ProxyName parameter as the host
name in the REGISTER's Request-URI and uses the
string configured by the IP Groups table parameter,
SIPGroupName as the host name in the To and From
headers. If the IP Group is configured with a Proxy Set
that has multiple IP addresses, all the REGISTER
messages sent to these proxies are sent with the same
host name.
Note: If the parameter is disabled and the ProxyName
parameter is not configured, the proxy's IP address is
used as the host name in the REGISTER Request-
URI.
'Redundancy Mode'
configure voip > sip-
definition proxy-and-
registration >
redundancy-mode
[ProxyRedundancyMode]
Determines whether the device switches back to the
primary Proxy after using a redundant Proxy.
■ [0] Parking = (Default) The device continues
working with a redundant (now active) Proxy until
the next failure, after which it works with the next
redundant Proxy.
■ [1] Homing = The device always tries to work with
the primary Proxy server (i.e., switches back to the
primary Proxy whenever it's available).
- 915 -