EasyManua.ls Logo

AudioCodes Mediant 4000 SBC - Network Application Parameters; General SIP Parameters

AudioCodes Mediant 4000 SBC
1037 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
Note: SIP response code 408 also refers to an INVITE
timeout (i.e., no reply from server). Therefore, if re-
registration is needed for such a scenario, make sure
that you configure the parameter with "408" as well.
Network Application Parameters
The SIP network application parameters are described in the table below.
Table 60-29:SIP Network Application Parameters
Parameter Description
configure voip > sip-
definition settings > tcp-
keepalive-time
[TCPKeepAliveTime]
Defines the interval (in sec) between the last data
packet sent and the first keep-alive probe to send.
The valid value is 10 to 65,000. The default is 60.
Note:
Simple ACKs such as keepalives are not
considered data packets.
TCP keepalive is enabled per SIP Interface in the
SIP Interfaces table.
configure voip > sip-
definition settings > tcp-
keepalive-interval
[TCPKeepAliveInterval]
Defines the interval (in sec) between consecutive
keep-alive probes, regardless of what the connection
has exchanged in the meantime.
The valid value is 10 to 65,000. The default is 10.
Note: TCP keepalive is enabled per SIP Interface in
the SIP Interfaces table.
configure voip > sip-
definition settings > tcp-
keepalive-retry
[TCPKeepAliveRetry]
Defines the number of unacknowledged keep-alive
probes to send before considering the connection
down.
The valid value is 1 to 100. The default is 5.
Note: TCP keepalive is enabled per SIP Interface in
the SIP Interfaces table.
General SIP Parameters
The general SIP parameters are described in the table below.
Table 60-30:General SIP Parameters
Parameter Description
[MaxSDPSessionVers
ionId]
Defines the maximum number of characters allowed in the SDP
body's "o=" (originator and session identifier) field for the session ID
and session version values. An example of an "o=" line with session
ID and session version values (in bold) is shown below:
o=jdoe 2890844526 2890842807 IN IP4 10.47.16.5
The valid value range is 1,000 to 214,748,3647 (default).
- 924 -

Table of Contents

Other manuals for AudioCodes Mediant 4000 SBC

Related product manuals