AudioCodes Mediant 4000 SBC - Answer and Disconnect Supervision Parameters

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
Note: For the parameter to take effect, a
device reset is required.
'SSE Payload Type Rx'
configure voip > media fax-modem >
V1501-SSE-payload-type-rx
[V1501SSEPayloadTypeRx]
Defines the V.150.1 (modem relay
protocol) State Signaling Event (SSE)
payload type Rx.
The value range is 96 to 127. The default
is 105.
'SSE Redundancy Depth'
configure voip > media fax-modem >
SSE-redundancy-depth
[V1501SSERedundancyDepth]
Defines the SSE redundancy depth.
The value range is 1-6. The default is 3.
'SPRT Transport Ch.0 Max Payload Size'
configure voip > media fax-modem >
SPRT-transport-channel0-max-payload-
size
[V1501SPRTTransportChannel0MaxPayloadSize]
Defines the maximum payload size for
V.150.1 SPRT Transport Channel 0.
The range is 140 to 256. The default is
140.
'SPRT Transport Ch.2 Max Payload Size'
configure voip > media fax-modem >
SPRT-transport-channel2-max-payload-
size
[V1501SPRTTransportChannel2MaxPayloadSize]
Defines the maximum payload size for
V.150.1 SPRT Transport Channel 2.
The range is 132 to 256. The default is
132.
'SPRT Transport Ch.2 Max Window Size'
configure voip > media fax-modem >
SPRT-transport-channel2-max-window-
size
[V1501SPRTTransportChannel2MaxWindowSize]
Defines the maximum window size of
SPRT transport channel 2.
The value range is 8 to 32. The default is
8.
'SPRT Transport Ch.3 Max Payload Size'
configure voip > media fax-modem >
SPRT-transport-channel3-max-payload-
size
[V1501SPRTTransportChannel3MaxPayloadSize]
Defines the maximum payload size for
V.150.1 SPRT Transport Channel 3.
The range is 140 to 256. The default is
140.
Answer and Disconnect Supervision Parameters
The answer and disconnect supervision parameters are described in the table below.
- 964 -