AudioCodes Mediant 500L - Page 374

User's Manual 374 Document #: LTRT-10532
Mediant 500L Gateway & E-SBC
Parameter Description
[IPGroup_InboundMan
Set]
Manipulation on page 415.
Note:
 The parameter is applicable only to the SBC application.
 The IPGroup_SIPGroupName parameter overrides inbound message
manipulation rules (assigned to the IPGroup_InboundManSet
parameter) that manipulate the host name in Request-URI, To, and/or
From SIP headers. If you want to manipulate the host name using
message manipulation rules in any of these SIP headers, you must
apply your manipulation rule (Manipulation Set ID) to the IP Group as an
Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is the
destination of the call.
Outbound Message
Manipulation Set
outbound-mesg-
manipulation-set
[IPGroup_OutboundMa
nSet]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the outbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see ''Configuring SIP Message
Manipulation'' on page 415.
Note: If you assign a Message Manipulation Set ID that includes rules for
manipulating the host name in the Request-URI, To, and/or From SIP
headers, the parameter overrides the IPGroup_SIPGroupName parameter.
Message Manipulation
User-Defined String 1
msg-man-user-defined-
string1
[IPGroup_MsgManUser
Def1]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by using
the following syntax:
param.ipg.<src|dst>.user-defined.<0>.
The valid value is a string of up to 30 characters. By default, no value is
defined.
To configure Message Manipulation rules, see ''Configuring SIP Message
Manipulation'' on page 415.
Message Manipulation
User-Defined String 2
msg-man-user-defined-
string2
[IPGroup_MsgManUser
Def2]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by using
the following syntax: param.ipg.<src|dst>.user-defined.<1>.
The valid value is a string of up to 30 characters. By default, no value is
defined.
To configure Message Manipulation rules, see ''Configuring SIP Message
Manipulation'' on page 415.
SBC Registration and Authentication
Max. Number of
Registered Users
max-num-of-reg-users
[IPGroup_MaxNumOfR
egUsers]
Defines the maximum number of users in this IP Group that can register
with the device.
The default is -1, meaning that no limitation exists for registered users.
Note: The parameter is applicable only to User-type IP Groups.
Registration Mode
registration-mode
[IPGroup_RegistrationM
ode]
Defines the registration mode for the IP Group:
 [0] User Initiates Registration (default)
 [1] SBC Initiates Registration = Used when the device serves as a client
(e.g., with an IP PBX). This functions only with the User Info file.
 [2] Registrations not Needed = The device adds users to its database in
active state.