AudioCodes Mediant 500L - Page 901

Version 7.2 901 Mediant 500L Gateway & E-SBC
User's Manual 56. Viewing VoIP Status
Table 56-5: IP Connectivity Table Description
Column Name Description
IP Address
Displays the destination IP address, which can be one of the following:
 Destination IP address as configured in the Tel-to-IP Routing table.
 Destination IP address resolved from the host name (FQDN) as configured
in the Tel-to-IP Routing table.
Host Name
Displays the host name (or IP address) as configured in the Tel-to-IP Routing
table.
Connectivity
Method
Displays the method according to which the destination IP address is queried
periodically by the device to check keep-alive connectivity status (SIP
OPTIONS request). To configure the keep-alive mechanism, see ''IP
Destinations Connectivity Feature'' on page 525.
Connectivity
Status
Displays the connectivity status with the destination:
 "OK": Remote side responds to periodic connectivity queries.
 "Lost": Remote side didn't respond for a short period.
 "Fail": Remote side doesn't respond.
 "Init": Connectivity queries not started (e.g., IP address not resolved).
 "Disable": The connectivity option is disabled, i.e., parameter 'Alt Routing
Tel to IP Mode' (AltRoutingTel2IPMode ini) is set to 'None' or 'QoS'. For
more information, see ''Alternative Routing Based on IP Connectivity'' on
page 526.
Quality Status
Displays the QoS (according to packet loss and delay) of the destination:
 "Unknown": Recent quality information isn't available.
 "OK"
 "Poor"
Note:
 The parameter is applicable only if the parameter 'Alt Routing Tel to IP
Mode' is set to 'QoS' or 'Both' (AltRoutingTel2IPMode = 2 or 3).
 The parameter is reset if two minutes elapse without a call to the
destination.
Quality Info
Displays QoS information: delay and packet loss, calculated according to
previous calls.
Note:
 The parameter is applicable only if the parameter 'Alt Routing Tel to IP
Mode' is set to 'QoS' or 'Both' (AltRoutingTel2IPMode = 2 or 3).
 The parameter is reset if two minutes elapse without a call to the
destination.
DNS Status
DNS status:
 "DNS Disable"
 "DNS Resolved"
 "DNS Unresolved"