AudioCodes Mediant 600 - RADIUS Parameters; A.5 RADIUS Parameters

SIP User's Manual 578 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.5 RADIUS Parameters
The RADIUS parameters are described in the table below. For supported RADIUS
attributes, see 'Supported RADIUS Attributes' on page 529.
Table A-26: RADIUS Parameters
Parameter Description
Web: Enable RADIUS Access
Control
[EnableRADIUS]
Enables the RADIUS application.
 [0] Disable = RADIUS application is disabled (default).
 [1] Enable = RADIUS application is enabled.
Note: For this parameter to take effect, a device reset is required.
Web: Accounting Server IP
Address
[RADIUSAccServerIP]
Defines the IP address of the RADIUS accounting server.
Web: Accounting Port
[RADIUSAccPort]
Defines the port of the RADIUS accounting server.
The default value is 1646.
Web/EMS: RADIUS Accounting
Type
[RADIUSAccountingType]
Determines when the RADIUS accounting messages are sent to
the RADIUS accounting server.
 [0] At Call Release = Sent at call release only (default).
 [1] At Connect & Release = Sent at call connect and release.
 [2] At Setup & Release = Sent at call setup and release.
Web: AAA Indications
EMS: Indications
[AAAIndications]
Determines the Authentication, Authorization and Accounting
(AAA) indications.
 [0] None = No indications (default).
 [3] Accounting Only = Only accounting indications are used.
Web: Device Behavior Upon
RADIUS Timeout
[BehaviorUponRadiusTimeout]
Defines the device's response upon a RADIUS timeout.
 [0] Deny Access = Denies access.
 [1] Verify Access Locally = Checks password locally (default).
[MaxRADIUSSessions]
Defines the number of concurrent calls that can communicate with
the RADIUS server (optional).
The valid range is 0 to 240. The default value is 240.
[RADIUSRetransmission]
Defines the number of retransmission retries.
The valid range is 1 to 10. The default value is 3.
[RadiusTO]
Defines the time interval (measured in seconds) that the device
waits for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default value is 10.
Web: RADIUS Authentication
Server IP Address
[RADIUSAuthServerIP]
Defines the IP address of the RADIUS authentication server.
Note: For this parameter to take effect, a device reset is required.
Web: RADIUS Authentication
Server Port
[RADIUSAuthPort]
Defines the port of the RADIUS Authentication Server.
Note: For this parameter to take effect, a device reset is required.
Web: RADIUS Shared Secret
[SharedSecret]
Defines the 'Secret' used to authenticate the device to the
RADIUS server. This should be a cryptically strong password.
Web: Default Access Level
Defines the default access level for the device when the RADIUS