SIP User's Manual 616 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
remote IP address is determined according to the Outbound IP
Routing table (Prefix parameter). The port is the same port as the
local RTP port (configured by the BaseUDPPort parameter and the
channel on which the call is received).
[0] Disable (default)
[1] Transmit & Receive = Send and receive RTP packets
[2] Transmit Only= Send RTP packets only
[3] Receive Only= Receive RTP packets only
Notes:
To activate the RTP Only feature without using ISDN / CAS
signaling, you must do the following:
Configure E1/T1 Transparent protocol type (set the
ProtocoType parameter to 5 or 6).
Enable the TDM-over-IP feature (set the EnableTDMoverIP
parameter to 1).
To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_ID parameter.
If per trunk configuration (using the RTPOnlyModeForTrunk_ID
parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
[RTPOnlyModeForTrunk_ID
]
Enables the RTP Only feature per trunk, where ID denotes the trunk
number (0 is the first trunk). For more information, see the
RTPOnlyMode parameter.
Note: For using the global parameter (i.e., setting the RTP Only
feature for all trunks), set this parameter to -1 (default).
Web/EMS: SIT Q850 Cause
[SITQ850Cause]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when a Special Information Tone
(SIT) is detected on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
Note: For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.
Web/EMS: SIT Q850 Cause
For NC
[SITQ850CauseForNC]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-NC (No Circuit Found
Special Information Tone) is detected from the PSTN for IP-to-Tel
calls.
The valid range is 0 to 127. The default value is 34.
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Web/EMS: SIT Q850 Cause
For IC
[SITQ850CauseForIC]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-IC (Operator Intercept
Special Information Tone) is detected from the PSTN for IP-to-Tel
calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Web/EMS: SIT Q850 Cause
For VC
[SITQ850CauseForVC]
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-VC (Vacant Circuit - non-
registered number Special Information Tone) is detected from the
PSTN for IP-to-Tel calls.
The valid range is 0 to 127. The default value is -1 (not configured).
To Next Page
Loading...
