AudioCodes Mediant 800 MSBG - Analoggw; Chargecode

CLI Reference Guide 112 Document #: LTRT-17940
System and VoIP Functionalities
5.16.2 analoggw
The following defines analoggw commands.
5.16.2.1 chargecode
This command defines the analog gateway chargecode settings.
Syntax:
# gw analoggw ChargeCode <index>
# set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 EndTime1
 EndTime2
 EndTime3
 EndTime4
 PulseInterval1
 PulseInterval2
 PulseInterval3
 PulseInterval4
 PulsesOnAnswer1
 PulsesOnAnswer2
 PulsesOnAnswer3
 PulsesOnAnswer4
 defaults
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example sets the pulse inetrval.
(config-voip)# gw analoggw ChargeCode 1
(ChargeCode-1)*# set EndTime1 pulsinterval1 20