Version 6.2 301 February 2011
SIP User's Manual 3. Web-Based Management
5. Click Next; the LAN bridge is successfully added.
Figure 3-235: LAN Bridge Successfully Added
6. Select the 'Edit the Connection' check box if you want to edit the new connection after
clicking Finish.
7. Click Finish to save the settings; the new bridge is added to the network connections
list.
3.3.3.9.5 Virtual LAN Interface (VLAN)
A virtual LAN interface enables you to group workstations together into one broadcast
domain, even if they are not located on the same LAN segment. The device allows you to
create virtual Ethernet-based networks according to the IEEE 802.1Q standard.
¾ To create a VLAN interface:
1. In the 'Connections' page, click the New
icon; the Connection Wizard opens.
2. Select the 'Advanced Connection' option, and then click Next; the 'Advanced
Connection' page appears.
3. Select the 'VLAN Interface' option, and then click Next; the following page appears.
Figure 3-236: Adding a VLAN Interface
Note: By default, all the device's physical LAN devices are enslaved by the device's
LAN bridge. A VLAN cannot be created over an enslaved network device.
Therefore, remove a device from the bridge before creating a VLAN over it.
4. From the 'Underlying Device' drop-down list, select the underlying device for this
interface. The list displays the device's Ethernet connections.
To Next Page
Loading...
