AudioCodes Mediant 800 MSBG - M Essage Waiting Indication Parameters

Version 6.2 767 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
Web: AS Subscribe IPGroupID
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not
configured).
Web: NRT Retry Subscription
Time
[NRTRetrySubscriptionTime]
Defines the Retry period (in seconds) for Dialog subscription if a
previous request failed.
The valid value range is 10 to 7200. The default is 120.
Web: Call Forward Ring Tone
ID
[CallForwardRingToneID]
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.
12.12.5.4 Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
Table 12-41: MWI Parameters
Parameter Description
Web: Enable MWI
EMS: MWI Enable
[EnableMWI]
Enables Message Waiting Indication (MWI).
 [0] Disable = Disabled (default).
 [1] Enable = MWI service is enabled.
Notes:
 This parameter is applicable only to FXS interfaces.
 The device supports only the receipt of SIP MWI NOTIFY
messages (the device doesn't generate these messages).
 For detailed information on MWI, see ''Message Waiting
Indication'' on page 461.
Web/EMS: MWI Analog Lamp
[MWIAnalogLamp]
Enables the visual display of MWI.
 [0] Disable = Disable (default).
 [1] Enable = Enables visual MWI by supplying line voltage
of approximately 100 VDC to activate the phone's lamp.
Notes:
 This parameter is applicable only for FXS interfaces.
 This parameter can also be configured per Tel Profile (using
the TelProfile parameter).
Web/EMS: MWI Display
[MWIDisplay]
Determines whether MWI information is sent to the phone
display.
 [0] Disable = MWI information isn't sent to display (default).
 [1] Enable = The device generates an MWI message
(determined by the parameter CallerIDType), which is
displayed on the MWI display.
Note:
 This parameter is applicable only to FXS interfaces.
 This parameter can also be configured per Tel Profile (using