SIP User's Manual 796 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
[262144] STATUS ERROR CAUSE = Clear call on
receipt of Status according to cause value.
[524288] ACCEPT A LAW =A-Law is also accepted in
5ESS.
[2097152] RESTART INDICATION = Upon receipt of a
Restart message, acEV_PSTN_RESTART_CONFIRM is
generated.
[4194304] FORCED RESTART = On data link
(re)initialization, send RESTART if there is no call.
[67108864] NS ACCEPT ANY CAUSE = Accept any
Q.850 cause from ISDN.
Note: This option is applicable only to Euro ISDN.
[134217728] NS_BRI_DL_ALWAYS_UP (0x08000000) =
By default, the BRI D-channel goes down if there are no
active calls. If this option is configured, the BRI D-channel
is always up and synchronized.
[536870912] Alcatel coding for redirect number and
display name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant
for specific Alcatel PBXs such as OXE).
[1073741824] QSI ENCODE INTEGER = If this bit is set,
INTEGER ASN.1 type is used in operator coding
(compliant to new ECMA standards); otherwise, OBJECT
IDENTIFIER ASN.1 type is used.
Note: This option is applicable only to QSIG.
[2147483648] 5ESS National Mode For Bch
Maintenance = Use the National mode of AT&T 5ESS for
B-channel maintenance.
Notes:
To configure the device to support several ISDNIBehavior
features, enter a summation of the individual feature
values. For example, to support both [512] and [2048]
features, set the parameter ISDNIBehavior is set to 2560
(i.e., 512 + 2048).
When configuring in the Web interface, to select the
options click the arrow button and then for each required
option select 1 to enable.
[ISDNIBehavior_x]
Same as the description for parameter ISDNIBehavior, but
for a specific trunk ID.
Web: General Call Control Behavior
EMS: General CC Behavior
[ISDNGeneralCCBehavior]
Bit-field for determining several general CC behavior
options. To select the options, click the arrow button, and
then for each required option, select 1 to enable. The default
is 0 (i.e., disable).
[2] = Data calls with interworking indication use 64 kbps
B-channels (physical only).
[8] REVERSE CHAN ALLOC ALGO = Channel ID
allocation algorithm.
[16] = The device clears down the call if it receives a
NOTIFY message specifying 'User-Suspended'. A
NOTIFY (User-Suspended) message is used by some
networks (e.g., in Italy or Denmark) to indicate that the
To Next Page
Loading...
