AudioCodes Mediant 800 MSBG - Page 807

Version 6.2 807 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
Web: Digital Out-Of-Service
Behavior
[DigitalOOSBehavior]
Determines the method for setting digital trunks to Out-Of-
Service state per device. For a description, refer to the
parameter DigitalOOSBehaviorFor Trunk_ID.
Note: To configure the method for setting Out-Of-Service state
per trunk, use the parameter DigitalOOSBehaviorForTrunk_ID.
Web: Default Cause Mapping From
ISDN to SIP
[DefaultCauseMapISDN2IP]
Defines a single default ISDN release cause that is used (in
ISDN-to-IP calls) instead of all received release causes, except
when the following Q.931 cause values are received: Normal
Call Clearing (16), User Busy (17), No User Responding (18),
or No Answer from User (19).
The range is any valid Q.931 release cause (0 to 127). The
default value is 0 (i.e., not configured - static mapping is used).
Web: Release Cause Mapping Table
EMS: ISDN to SIP Cause Mapping
[CauseMapISDN2SIP]
This ini file table parameter maps ISDN Q.850 Release Causes
to SIP responses.
The format of this parameter is as follows:
[CauseMapISDN2SIP]
FORMAT CauseMapISDN2SIP_Index =
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse;
[\CauseMapISDN2SIP]
Where,
 IsdnReleaseCause = Q.850 Release Cause
 SipResponse = SIP Response
For example:
CauseMapISDN2SIP 0 = 50,480;
CauseMapISDN2SIP 0 = 6,406;
When a Release Cause is received (from the PSTN side), the
device searches this mapping table for a match. If the Q.850
Release Cause is found, the SIP response assigned to it is sent
to the IP side. If no match is found, the default static mapping is
used.
Notes:
 This parameter can appear up to 12 times.
 For an explanation on ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.
Web: Release Cause Mapping Table
EMS: SIP to ISDN Cause Mapping
[CauseMapSIP2ISDN]
This ini file table parameter maps SIP responses to Q.850
Release Causes. The format of this parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
[\CauseMapSIP2ISDN]
Where,