SIP User's Manual 808 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
SipResponse = SIP Response
IsdnReleaseCause = Q.850 Release Cause
For example:
CauseMapSIP2ISDN 0 = 480,50;
CauseMapSIP2ISDN 0 = 404,3;
When a SIP response is received (from the IP side), the device
searches this mapping table for a match. If the SIP response is
found, the Q.850 Release Cause assigned to it is sent to the
PSTN. If no match is found, the default static mapping is used.
Notes:
This parameter can appear up to 12 times.
For an explanation on ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.
[UserToUserHeaderFormat]
Determines the format of the User-to-User SIP header in the
INVITE message for interworking the ISDN User to User (UU)
IE data to SIP.
[0] = Format: X-UserToUser (default).
[1] = Format: User-to-User with Protocol Discriminator (pd)
attribute.
User-to-
User=3030373435313734313635353b313233343b3834;pd
=4. (This format is according to IETF Internet-Draft draft-
johnston-sipping-cc-uui-04.)
[2] = Format: User-to-User with encoding=hex at the end
and pd embedded as the first byte.
User-to-
User=043030373435313734313635353b313233343b3834;
encoding=hex. Where "04" at the beginning of this message
is the pd. (This format is according to IETF Internet-Draft
draft-johnston-sipping-cc-uui-03.)
Web/EMS: Remove CLI when
Restricted
[RemoveCLIWhenRestricted]
Determines (for IP-to-Tel calls) whether the Calling Number
and Calling Name IEs are removed from the ISDN Setup
message if the presentation is set to Restricted.
[0] No = IE's are not removed (default).
[1] Yes = IE's are removed.
Web/EMS: Remove Calling Name
[RemoveCallingName]
Enables the device to remove the Calling Name from SIP-to-
ISDN calls for all trunks.
[0] Disable = Does not remove Calling Name (default).
[1] Enable = Removes Calling Name.
Web: Remove Calling Name
EMS: Remove Calling Name For
Trunk Mode
[RemoveCallingNameForTrunk_I
D]
Enables the device to remove the Calling Name per trunk
(where ID denotes the trunk number) for SIP-to-ISDN calls.
[-1] Use Global Parameter = Settings of the global
parameter RemoveCallingName are used (default).
[0] Disable = Does not remove Calling Name.
[1] Enable = Remove Calling Name.
Web/EMS: Progress Indicator to
ISDN
[ProgressIndicator2ISDN_ID]
Progress Indicator (PI) to ISDN. The ID in the ini file parameter
depicts the trunk number, where 0 is the first trunk.
[-1] Not Configured = The PI in ISDN messages is set
To Next Page
Loading...
