AudioCodes Mediant 800 MSBG - Page 852

SIP User's Manual 852 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Web: Destination Phone Number Manipulation Table for Tel to IP Calls
EMS: SIP Manipulations > Destination Telcom to IPs
[NumberMapTel2IP]
This ini file table parameter manipulates the destination number
of Tel-to-IP calls. The format of this parameter is as follows:
[NumberMapTel2Ip]
FORMAT NumberMapTel2Ip_Index =
NumberMapTel2Ip_DestinationPrefix,
NumberMapTel2Ip_SourcePrefix,
NumberMapTel2Ip_SourceAddress,
NumberMapTel2Ip_NumberType,
NumberMapTel2Ip_NumberPlan,
NumberMapTel2Ip_RemoveFromLeft,
NumberMapTel2Ip_RemoveFromRight,
NumberMapTel2Ip_LeaveFromRight,
NumberMapTel2Ip_Prefix2Add, NumberMapTel2Ip_Suffix2Add,
NumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID, NumberMapTel2Ip_
SrcIPGroupID;
[\NumberMapTel2Ip]
For example:
NumberMapTel2Ip 0 = 01,$$,*,0,0,2,$$,$$,971,$$,$$,$$,$$;
NumberMapTel2Ip 1 = 10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
Notes:
 This table parameter can include up to 120 indices (0-119).
 The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight,
Prefix2Add, and then Suffix2Add.
 If the called and calling numbers match the DestinationPrefix
and/or SourcePrefix conditions, then the parameters
NumberType, NumberPlan, RemoveFromLeft,
RemoveFromRight, Prefix2Add, Suffix2Add, and/or
LeaveFromRight are applied.
 Number Plan and Type can be used in the Remote-Party-ID
header by configuring the EnableRPIHeader and
AddTON2RPI parameters.
 The following parameters are not applicable: SourceAddress
and IsPresentationRestricted.
 To configure manipulation of destination numbers for Tel-to-IP
calls using the Web interface, see ''Configuring the Number
Manipulation Tables'' on page 152).
 For a description on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.
Web: Destination Phone Number Manipulation Table for IP to Tel Calls
EMS: EMS: SIP Manipulations > Destination IP to Telcom
[NumberMapIP2Tel]
This ini file table parameter manipulates the destination number
of IP-to-Tel calls. The format of this parameter is as follows:
[NumberMapIp2Tel]
FORMAT NumberMapIp2Tel_Index =
NumberMapIp2Tel_DestinationPrefix,
NumberMapIp2Tel_SourcePrefix,
NumberMapIp2Tel_SourceAddress,