AudioCodes Mediant 800 MSBG - Page 854

SIP User's Manual 854 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Web: Source Phone Number Manipulation Table for Tel to IP Calls
EMS: SIP Manipulations > Source Telcom to IP
[SourceNumberMapTel2IP]
This ini file table parameter manipulates the source phone
number for Tel-to-IP calls. The format of this parameter is as
follows:
[SourceNumberMapTel2Ip]
FORMAT SourceNumberMapTel2Ip_Index =
SourceNumberMapTel2Ip_DestinationPrefix,
SourceNumberMapTel2Ip_SourcePrefix,
SourceNumberMapTel2Ip_SourceAddress,
SourceNumberMapTel2Ip_NumberType,
SourceNumberMapTel2Ip_NumberPlan,
SourceNumberMapTel2Ip_RemoveFromLeft,
SourceNumberMapTel2Ip_RemoveFromRight,
SourceNumberMapTel2Ip_LeaveFromRight,
SourceNumberMapTel2Ip_Prefix2Add,
SourceNumberMapTel2Ip_Suffix2Add,
SourceNumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID,
NumberMapTel2Ip_SrcIPGroupID;
[\SourceNumberMapTel2Ip]
For example:
SourceNumberMapTel2Ip 0 =
22,03,$$,0,0,$$,2,$$,667,$$,0,$$,$$;
SourceNumberMapTel2Ip 0 =
10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
Notes:
 This table parameter can include up to 120 indices.
 The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight,
Prefix2Add, and then Suffix2Add.
 If the called and calling numbers match the DestinationPrefix
and/or SourcePrefix conditions, then the RemoveFromLeft,
RemoveFromRight, Prefix2Add, Suffix2Add, LeaveFromRight,
NumberType, NumberPlan, and/or IsPresentationRestricted
are applied.
 An asterisk ('*') represents all IP addresses.
 IsPresentationRestricted is set to 'Restricted' only if 'Asserted
Identity Mode' is set to 'P-Asserted'.
 Number Plan and Type can optionally be used in the Remote
Party ID header by configuring the EnableRPIHeader and
AddTON2RPI parameters.
 To configure manipulation of source numbers for Tel-to-IP
calls using the Web interface, see ''Configuring Number
Manipulation Tables'' on page 152).
 For a description on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.