Version 6.2 855 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
Web: Source Phone Number Manipulation Table for IP to Tel Calls
EMS: EMS: SIP Manipulations > Source IP to Telcom
[SourceNumberMapIP2Tel]
This ini file table parameter manipulates the source number for
IP-to-Tel calls. The format of this parameter is as follows:
[SourceNumberMapIp2Tel]
FORMAT SourceNumberMapIp2Tel_Index =
SourceNumberMapIp2Tel_DestinationPrefix,
SourceNumberMapIp2Tel_SourcePrefix,
SourceNumberMapIp2Tel_SourceAddress,
SourceNumberMapIp2Tel_NumberType,
SourceNumberMapIp2Tel_NumberPlan,
SourceNumberMapIp2Tel_RemoveFromLeft,
SourceNumberMapIp2Tel_RemoveFromRight,
SourceNumberMapIp2Tel_LeaveFromRight,
SourceNumberMapIp2Tel_Prefix2Add,
SourceNumberMapIp2Tel_Suffix2Add,
SourceNumberMapIp2Tel_IsPresentationRestricted;
[\SourceNumberMapIp2Tel]
For example:
SourceNumberMapIp2Tel 0 = 22,03,$$,$$,$$,$$,2,667,$$,$$;
SourceNumberMapIp2Tel 1 =
034,01,1.1.1.1,$$,0,2,$$,$$,972,$$,10;
Notes:
This table parameter can include up to 120 indices.
The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight,
Prefix2Add, and then Suffix2Add.
If the called and calling numbers match the DestinationPrefix,
SourcePrefix, and/or SourceAddress conditions, then the
RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add, LeaveFromRight, NumberType, and/or
NumberPlan are applied.
9 'x': represents single digits. For example: 10.8.8.xx
represents addresses between 10.8.8.10 and 10.8.8.99.
9 '*' (asterisk): represents any number between 0 and 255.
For example, 10.8.8.* represents addresses between
10.8.8.0 and 10.8.8.255.
To configure manipulation of source numbers for IP-to-Tel
calls using the Web interface, see ''Configuring Number
Manipulation Tables'' on page 152).
For a description on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.
[PerformAdditionalIP2TELSour
ceManipulation]
Enables additional source number manipulation for IP-to-Tel
calls. The additional manipulation is done on the initially
manipulated source number, and this additional rule is also
configured in the manipulation table (SourceNumberMapIP2Tel
parameter). This enables you to configure only a few
manipulation rules for complex number manipulation
requirements (that generally require many rules).
[0] = Disable (default)
[1] = Enable
To Next Page
Loading...
