AudioCodes Mediant 800 - Page 1029

CHAPTER53 System Status
Mediant 800 Gateway & E-SBC | User's Manual
4. To view additional channel information, click the required tab - SIP, RTP/RTCP, and Voice
Settings.
Table 53-3: Port Status Description
Field Description
SIP
Endpoint Status Status of endpoint:
■ "IDLE": No call
■ "ACTIVE": Active call
Assigned Phone
Number
Phone number of the port.
Hunt Group Trunk Group to which the port is assigned. To configure Trunk Groups,
see see Configuring Trunk Groups.
MWI Information Indicates if the phone has a voice-mail message (Message Waiting
Indicator):
■ "yes": Endpoint has a voice-mail message.
■ "...": No voice mail for the endpoint.
Note: The field is applicable only to FXS interfaces.
Call ID Call ID number of the call (SIP Call-ID header).
Call Originator Caller:
■ "TEL": Call made from Tel side (i.e., the port)
■ "IP": Call made from IP side
Source Tel
Number
Telephone number of the caller.
Destination Tel
Number
Telephone number of the called party.
Redirect Calling
Number
Telephone number of the redirected number.
Remote Signaling
IP
IP address used for SIP on the IP side.
Remote RTP
(IP:Port)
IP address and port used for RTP on the IP side.
Call Establishment
Duration
Length of time (in seconds) it took to establish the call.
Call Duration Call duration (in seconds) from when call was established.
Call State Current state of the call:
■ "IDLE": No call.
■ "SETUP": Signaling to setup call (SIP INVITE).
■ "ALERT": Ringing at remote end (SIP 180 Ringing).
■ "RINGBACK": Ringback played to port.
- 989 -