AudioCodes Mediant 800 - Page 1225

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
Regional Clock and Daylight Saving Time Parameters
'UTC Offset'
configure system >
clock > utc-offset
[NTPServerUTCOffset]
Defines the Universal Time Coordinate (UTC) offset (in
seconds) from the local time.
The valid range is -86400 seconds (i.e., -24 hours) to +86400
seconds (i.e., +24 hours). The default is 0.
Note: The offset setting is applied only on the hour. For
example, if you configure the parameter at 15:42, the device
applies the setting only at 16:00.
'Daylight Saving Time'
configure system >
clock > summer-time >
summer-time
[DayLightSavingTimeEnable]
Enables daylight saving time (DST).
■ [0] Disable (default)
■ [1] Enable
'Start Time / Day of Month
Start'
configure system >
clock > summer-time >
start
[DayLightSavingTimeStart]
Defines the date and time when DST begins. This value can
be configured using any of the following formats:
■ Day of year - mm:dd:hh:mm, where:
✔ mm denotes month
✔ dd denotes date of the month
✔ hh denotes hour
✔ mm denotes minutes
For example, "05:01:08:00" denotes daylight saving start-
ing from May 1 at 8 A.M.
■ Day of month - mm:day/wk:hh:mm, where:
✔ mm denotes month (e.g., 04)
✔ day denotes day of week (e.g., FRI)
✔ wk denotes week of the month (e.g., 03)
✔ hh denotes hour (e.g., 23)
✔ mm denotes minutes (e.g., 10)
For example, "04:FRI/03:23:00" denotes Friday, the third
week of April, at 11 P.M. The week field can be 1-5,
where 5 denotes the last occurrence of the specified day
in the specified month. For example, "04:FRI/05:23:00"
denotes the last Friday of April, at 11 P.M.
'End Time / Day of Month End'
configure system >
clock > summer-time >
end
[DayLightSavingTimeEnd]
Defines the date and time when DST ends. For a description
of the format of this value, see the DayLightSavingTimeStart
parameter.
'Offset'
configure system >
clock > summer-time >
offset
[DayLightSavingTimeOffset]
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For
example, if you configure the parameter at 15:42, the device
applies the setting only at 16:00.
- 1185 -