AudioCodes Mediant 800 - Page 1431

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
'Replace Empty Destination with B-channel
Phone Number'
configure voip > gateway routing
settings > empty-dst-w-bch-nb
[ReplaceEmptyDstWithPortNumber]
Determines whether the internal channel
number is used as the destination number if
the called number is missing.
■ [0] No (default)
■ [1] Yes
Note:
■ The parameter is applicable only to Tel-
to-IP calls and if the called number is
missing.
■ The parameter is applicable only to
digital interfaces.
[CopyDestOnEmptySource] Determines whether the destination number
is copied to the source number if no source
number is present, for Tel-to-IP calls.
■ [0] = (Default) Source Number is left
empty.
■ [1] = If the Source Number of a Tel-to-IP
call is empty, the Destination Number is
copied to the Source Number.
Note: The parameter is applicable only to
digital interfaces.
'Add NPI and TON to Calling Number'
configure voip > gateway routing
settings > npi-n-ton-to-cng-nb
[AddNPIandTON2CallingNumber]
Determines whether the Numbering Plan
Indicator (NPI) and Type of Numbering
(TON) are added to the Calling Number for
Tel-to-IP calls.
■ [0] No = (Default) Do not change the
Calling Number.
■ [1] Yes = Add NPI and TON to the
Calling Number ISDN Tel-to-IP call.
For example: After receiving a Calling
Number of 555, NPI of 1, and TON of 3, the
modified number becomes 13555. This
number can later be used for manipulation
and routing.
Note: The parameter is applicable only to
digital interfaces.
'Add NPI and TON to Called Number'
configure voip > gateway routing
settings > npi-n-ton-to-cld-nb
[AddNPIandTON2CalledNumber]
Determines whether NPI and TON are
added to the Called Number for Tel-to-IP
calls.
■ [0] No = (Default) Do not change the
Called Number.
■ [1] Yes = Add NPI and TON to the
Called Number of ISDN Tel-to-IP call.
- 1391 -