EasyManua.ls Logo

AudioCodes Mediant 800 - Page 596

AudioCodes Mediant 800
1482 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER23 Digital PSTN
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
[128] SEND USER CONNECT ACK = The Connect
ACK message is sent in response to received Q.931
Connect; otherwise, the Connect ACK is not sent.
Note: This option is applicable only to Euro ISDN User
side outgoing calls.
[512] EXPLICIT INTERFACE ID = Enables configuration
of T1 NFAS Interface ID (refer to the parameter
ISDNNFASInterfaceID_x).
Note: This value is applicable only to 4/5ESS, DMS, NI-2
and HKT variants.
[2048] ALWAYS EXPLICIT = Always set the Channel
Identification IE to explicit Interface ID, even if the B-
channel is on the same trunk as the D-channel.
Note: This value is applicable only to 4/5ESS, DMS and
NI-2 variants.
[32768] ACCEPT MU LAW =Mu-Law is also accepted in
ETSI.
[65536] EXPLICIT PRES SCREENING = The calling
party number (octet 3a) is always present even when
presentation and screening are at their default.
Note: This option is applicable only to ETSI, NI-2, and
5ESS.
[131072] STATUS INCOMPATIBLE STATE = Clears
the call on receipt of Q.931 Status with incompatible state.
Otherwise, no action is taken (default).
[262144] STATUS ERROR CAUSE = Clear call on
receipt of Status according to cause value.
[524288] ACCEPT A LAW =A-Law is also accepted in
5ESS.
[2097152] RESTART INDICATION = Upon receipt of a
Restart message, acEV_PSTN_RESTART_CONFIRM is
generated.
[4194304] FORCED RESTART = On data link
(re)initialization, send RESTART if there is no call.
[67108864] NS ACCEPT ANY CAUSE = Accept any
Q.850 Cause IE from ISDN.
Note: This option is applicable only to Euro ISDN.
[134217728] NS_BRI_DL_ALWAYS_UP (0x08000000)
= By default, the BRI D-channel goes down if there are no
active calls. If this option is configured, the BRI D-channel
is always up and synchronized.
[536870912] = Alcatel coding for redirect number and
display name is accepted by the device.
Note: This option is applicable only to QSIG (and relevant
for specific Alcatel PBXs such as OXE).
- 556 -

Table of Contents

Other manuals for AudioCodes Mediant 800

Related product manuals