AudioCodes Mediant 800 - Page 758

CHAPTER29 Analog Gateway
Mediant 800 Gateway & E-SBC | User's Manual
The feature is applicable only to FXS and FXO interfaces.
The following procedure describes how to configure automatic dialing upon off-hook through the
Web interface. You can also configure it through ini file [TargetOfChannel] or CLI (configure
voip > gateway analog automatic-dialing).
➢ To configure automatic dialing per port:
1. Open the Automatic Dialing table (Setup menu > Signaling & Media tab > Gateway folder >
Analog Gateway > Automatic Dialing).
2. Select the row corresponding to the port that you want to configure, and then click Edit; the
following dialog box appears:
3. Configure automatic dialing per port according to the parameters described in the table below.
4. Click Apply.
Table 29-2: Automatic Dialing Table Parameter Descriptions
Parameter Description
'Index'
[TargetOfChannel_
Index]
(Read-only) Displays the index number of the table row.
'Module'
[TargetOfChannel_
Module]
(Read-only) Displays the module number on which the port is
located.
'Port'
port
[TargetOfChannel_
Port]
(Read-only) Displays the port number.
'Port Type'
[TargetOfChannel_
PortType]
(Read-only) Displays the port type (FXS or FXO).
'Destination Phone
Number'
dst-number
[TargetOfChannel_
Destination]
Defines the destination telephone number to automatically dial.
- 718 -