Installation & Operation Manual 490 Document # LTRT-92224
Mediant 8000
15. On the Mediant 8000, verify that the Operational State of all configured entities
(i.e. SS7 Node, SS7 Linkset, SS7 Routeset, SS7 Data Link, UAL Group and
E1/T1 Trunk) is Enabled.
Table 38-12: MTP3 Group Properties
Parameter Name Type
Provisioning
Type
Description
Mtp3 Group
Name
String
Up to 20 chars.
Instant The textual, user-defined name for the SS7
MTP3 Group, enabling it to be identified
intuitively and easily.
Redundancy
Mode
Enum
none, dualCpu
Online Defines the Redundancy mode.
For a simple configuration, where only one
Media Gateway board is associated with
the MTP3 Group, define the Redundancy
Mode as none. In this configuration, the
MTP3/M3UA application does not survive
the Media Gateway boards' switchover (All
MTP3 entities go out of service.)
For a redundant MTP3 configuration,
where two Media Gateway boards are
associated with the same MTP3 Group
and signaling node is distributed
across both boards, define the
Redundancy Mode as dualCpu. In this
configuration the MTP3/M3UA
application is preserved during Media
Gateway boards'
switchover/switchback.
To Next Page
Loading...
