AudioCodes Mediant 800B - Page 1113

Version 7.2 1113 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description

[2] Full = Caches all challenges from the proxies.
Note:
 Challenge caching is used with all proxies and not only with
the active one.
 For the Gateway application: The challenge can be cached
per endpoint or per Account.
 For the SBC application: The challenge can be cached per
Account or per user whose credentials are known through the
User Info table.
Proxy Address Table
Proxy IP Table
configure voip > proxy-ip
[ProxyIP]
The table defines proxy addresses per Proxy Set.
The format of the ini file table parameter is as follows:
[ProxyIP]
FORMAT ProxyIp_Index = ProxyIp_ProxySetId,
ProxyIp_ProxyIpIndex, ProxyIp_IpAddress,
ProxyIp_TransportType;
[\ProxyIP]
For more information, see 'Configuring Proxy Sets' on page 380.
Proxy Sets Table
Proxy Sets
configure voip > proxy-set
[ProxySet]
Defines the Proxy Sets.
The format of the ini file table parameter is as follows:
[ ProxySet ]
FORMAT ProxySet_Index = ProxySet_ProxyName,
ProxySet_EnableProxyKeepAlive,
ProxySet_ProxyKeepAliveTime,
ProxySet_ProxyLoadBalancingMethod,
ProxySet_IsProxyHotSwap, ProxySet_SRDName,
ProxySet_ClassificationInput, ProxySet_TLSContextName,
ProxySet_ProxyRedundancyMode,
ProxySet_DNSResolveMethod, ProxySet_KeepAliveFailureResp,
ProxySet_GWIPv4SIPInterfaceName,
ProxySet_SBCIPv4SIPInterfaceName,
ProxySet_GWIPv6SIPInterfaceName,
ProxySet_SBCIPv6SIPInterfaceName,
ProxySet_MinActiveServersLB,
ProxySet_SuccessDetectionRetries,
ProxySet_SuccessDetectionInterval,
ProxySet_FailureDetectionRetransmissions;
[ \ProxySet ]
For more information, see 'Configuring Proxy Sets' on page 380.
Registrar Parameters
Enable Registration
configure voip > sip-definition
settings > enable-registration
[IsRegisterNeeded]
Enables the device to register to a Proxy/Registrar server.
 [0] Disable = (Default) The device doesn't register to
Proxy/Registrar server.
 [1] Enable = The device registers to Proxy/Registrar server
when the device is powered up and at every user-defined
interval (configured by the parameter RegistrationTime).
Note: