Quick Setup
Connect the included speaker wire from the HD5 le (powered) speaker
to the right (passive) speaker.
Connect the Bluetooth antenna to the HD5 rear panel.
Connect the AC power cord to the HD5 rear panel and plug the other
end into a power outlet.
Wireless connection
Turn on the HD5 power switch located on the rear panel. HD5 will
automatically go into Bluetooth “pair mode” and the Pair button on the
HD5 rear panel will flash.
On your device (phone, tablet, computer, etc), turn on Bluetooth and go
to Bluetooth preferences.
Select “Audioengine HD5” to pair and connect. The Pair indicator on the
HD5 rear panel should be solid.
Play your music and adjust volume levels on HD5 and your device.
To add additional devices put HD5 back into pair mode by disconnect-
ing HD5 from your device or by pressing and holding the Pair button on
the HD5 rear panel until the pair indicator starts flashing.
HD5 can wirelessly connect to only one device at a time, however it will
remember up to six dierent devices.
Wired connection
Connect one of the included audio cables to your music source (phone,
tablet, computer, TV, etc.) and the other end to an input on the HD5 rear
panel.
Play your music and adjust the volume on the speakers and your device
to the desired listening levels.
8
9
1
2
3
4
5
5
5
6
5
7
To Next Page
Loading...
Need help?
General
