PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
• Do not use the unit in places which are extremely
hot, cold, dusty, or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing
it in a place with poor air flow, by covering it
with a cloth, or by placing it on a carpet.
ON AC VOLTAGE
• Before use, check that the rated voltage of
your unit matches your local voltage.
FCC INFORMATION (FOR USA ONLY)
This device complies with Part 15 of FCC Rules.
Operations are subject to the following two
conditions:
(1)This device may not cause harmful
interference, and (2) This device must accept
any interference received, including interference
that may cause undesirable operations.
ON SAFETY
• When connecting or disconnecting the AC cord,
grip the plug and not the cord itself. Pulling the
cord may damage it and create a hazard.
• When you are not going to use the unit for
a long period of time, disconnect the AC power
cord.
ON CONDENSATION
• When left in a heated room where it is warm
and damp, water droplets or condensation may
form inside the CD player.
• When there is condensation inside the unit, the
unit may not function normally.
• Let it stand for 1 to 2 hours before turning the
power on, or gradually heat the room up and
dry the unit before use.
Should any trouble occur, disconnect the AC
power cord and refer servicing to qualified
personnel.
SYSTEM CONNECTIONS
SPEAKERS CONNECTING
• Connect the wires to the speaker terminals in correct
position.
• Connect speakers other than the speakers supplied with
the unit may damage the unit.
AC POWER CONNECTING
• Before use, check that the rated voltage of your unit
matches your local voltage. Make sure speakers
are connected correctly before plugging the AC
power cord into an AC outlet.
CAUTION :
• Be sure the AC power cord is disconnected and all functions are off before making connections.
• TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT
(FOR USA AND CANADA ONLY).
FM ANTENNA
• Do not connect to an outside antenna.
PARTS IDENTIFICATION
1. CD door
2. POWER/STANDBY indicator
3. VOLUME control
4. ON indicator
5. FM STEREO indicator
6. PHONES jack
7. FUNCTION switch (ST.BY/
TUNER/CD)
8. CD OPEN/CLOSE button
9. PROGRAM button
10. REPEAT button
11. CD PLAY/PAUSE/STOP button
12. CD display
13. TUNING control
14. Remote sensor (optional)
15. Mode selector (FM.ST/FM MONO)
16. BAND selector (FM/AM)
17. DISC SKIP button
18. CD SKIP/SEARCH buttons
19. CD STORAGE door
GENERAL OPERATION
COMPACT DISC (CD) DISPLAY
1. REPEAT mode indicators
2. DISC indicator
3. Playback indicator
4. Pause indicator
5.Track indicator
RADIO OPERATION
1. Set the FUNCTION
switch to TUNER.
2. Select the desired
band.
4. Adjust the volume.
3. Tune into a station.
SOUND ADJUSTMENT
TO ADJUST THE VOLUME
Adjust the VOLUME control to obtain the desired volume level.
FOR PERSONAL LISTENING
Connect headphones ( Ø3.5mm stereo mini plug) to the PHONES jack.
Adjust the VOLUME for the desired listening level.
When headphones are connected, the speakers are automatically discon-
nected.
TO RECEIVE THE FM BROADCAST IN STEREO
Set the Mode selector to FM.ST.
When the FM STEREO broadcast is received, FM
STEREO indicator lights up.
AFTER LISTENING
Set the FUNCTION switch to ST.BY (Standby).
FOR BETTER RECEPTION
Fully unwind the wire antenna. Then extend the wire antenna and place it in the position that sounds best.
NOTE:
DO NOT CONNECT FM ANTENNA WIRE TO OUTSIDE ANTENNA.
Rotate the unit to get the best receiving position.
AM / MW
FM
COMPACT DISC PLAYBACK
1. Set the FUNCTION switch to CD.
2. Press the OPEN/CLOSE button to open the disc tray. Place
the first disc onto the disc holder, with the label side up.
3.Press the DISC SKIP button to revolve the tray
clockwise.
Place other disc(s) on the disc holder(s).
WARNING: Take out all discs from the disc tray before
transportation.
To stop playing:
a) For a moment only, press
PLAY / PAUSE button and " " will be displayed. Press this button again to
resume playing.
b) Press CD
STOP button.
NOTE:
• To locate a track of currently selected disc, press
or SKIP/SEARCH button repeatedly.
• To locate a track of another disc, press DISC SKIP button to get to desired disc first and then press
or SKIP/SEARCH button repeatedly.
• To search a track, keep
or SKIP/SEARCH button pressed and release it at desired point.
5. Press the DISC SKIP button to select the
desired disc. Press either one of the SKIP/
SEARCH buttons to select the desired track.
6. Press PLAY/PAUSE button to start playback.
To repeat the current track
• Press REPEAT button until REPEAT ONE appears on the CD
display and the currently playing track will be played repeatedly.
• Press
or SKIP/SEARCH button with repeat function on,
repeat can still skip through different tracks of the currently selected disc.
To repeat the whole disc
• By pressing the REPEAT button until REPEAT ONE DISC appears
on the CD display, the current disc will be played repeatedly starting
from the currently playing point.
• By pressing
or SKIP/SEARCH button with REPEAT-ONE-
DISC function on, one can still search through the whole disc, and
the player will start playing from the selected point.
To repeat all discs
• Press REPEAT button until REPEAT ALL DISC appears on the
CD display.
• By pressing on
or SKIP/SEARCH button will make the
player start playing from the newly selected point of the currently
playing disc.
• By pressing on DISC SKIP button will make the player start playing
from the first track of the newly selected disc. The
or SKIP/
SEARCH button can be used to choose a particular track on this
selected disc, the player will then start playing from that point.
To cancel repeat play
• Press REPEAT button until the 'REPEAT' icon disappears from the
CD display.
CD REPEAT PLAYBACK
REPEAT PLAYBACK - DURING PLAYBACK MODE
IF THE FM BROADCAST SIGNAL IS WEAK
Set the Mode selector to FM MONO position to
turn off the FM STEREO indicator and back-
ground noises become monaural.
4. Press the OPEN/CLOSE button to close the disc tray. It takes a short while for your player to check the discs.
ATTENTION - If the CD player does not operate properly
2. Slide the FUNCTION switch from ST.BY to CD.
1. Slide the FUNCTION switch from CD to ST.BY.
(standby)
PRESS IT REPEATEDLY
FORWARD
SKIP
REVERSE
SKIP
REVERSE
SEARCH
KEEP IT PRESSED
FORWARD
SEARCH
1
2
To Previous Page
Loading...