S = store function, hold & pres with 1 ,2,3 or 4 for
storing the position
Arrowup = Up direction for finding the build-in height
position.
Arrow down = Down direction for finding the projection
position.
1 = Preset / programmed position build-in position
(closed). Use this contact for external permanent
control with contact relay.
2 = Preset / programmed position of presentation
position.
Use this contact for external permanent control with
contact relay.
3 & 4 can be used as additional positions (only through
RS232)
S = Common, use in combination with contacts
1 -4.
Keyboard
RS232 connection
(RJ45)
Control connector
(loop + 1 + 2)
Fuse
24 VDC in
NEW RS232 control for PCL lift systems
Connecting the Mirror-Kit.
For first use, the lift can be used to control the travel and
build-in height. Use the arrows to do so.
For external control use at least 0,5-0,75 mm wires for long
distances up to 15 meters in combination with a relay per
each direction / position.
Use the extra booklet for RS232 instructions.
© Audipack
PCL-M350 and PCL-X350 only
12.1
To Next Page
Loading...