If there are UPGRADE Firmware available online product, proceed as described below.
1. Download from the portal bits Drive http://www.audisonbitdrive.eu/index.php?r=ssupport the file “DRC_MP_update_x.x.zip”,
and save it to your PC
2. Unzip the saved file , and save the folder “DRC MP x.x update” in your PC desktop.
3. Connect the DRC MP to an Audison bit product.
4. Connect the USB port of the PC to Audiosn bit product. The Audison bit product connected to your PC must have its
appropriate PC software of Audison bit installed.
5. Turn on the system.
6. Open the folder “MP DRC update x.x” and run the “DRC_MP_update” program
NOTE: Before starting the DRC MP update remember to:
- Do not disconnect the USB plug from the PC.
- Do not disconnect THE DRC MP from Audison bit product.
- Temporarily disable the automatic suspension processes on your PC.
- Temporarily disable the Screen Saver processes on your PC.
- Close all other open applications.
- Temporarily disable anti-virus and anti-spyware systems.
7. Select the Audison connected device and then press the button 9, from your PC keyboard
8. After the upgrade, unplug the USB cable.
WARNING: POSSIBLE ERROR MESSAGE
In case you found an error screen exit the updater and upgrade the .NET FRAMEWORK in your PC as shown below :
- Open the folder “MP DRC update x.x“ then the folder “.NET Framework“.
- Run the “dotNetFx40_Full_x86_x64“ System update files.
-Completed Upgrade restart your PC and repeat the update procedure previously reported from step 3.
7
To Next Page
Loading...
Need help?
General