AUMA SAExC 16.1 - Assembly; Handwheel Fitting

4. Assembly
4.1. Handwheel fitting
Information For transport purposes, handwheels from a diameter of 400 mm are sup
-
plied separately.
1. Manually lift the red change-over lever while slightly turning the shaft
bac
k and forth until manual operation engages.
The manual operation is correctly engaged if the change-over lever can
be lifted by approx. 85°.
2. Attach handwheel over the red change-over lever then on to the shaft.
3. Secure handwheel using the circlip supplied.
11
Multi-turn actuator SAExC 07.1 – SAExC 16.1/SARExC 07.1 – SARExC 16.1
Non-Intrusive
Operation instructions with actuator controls AUMATIC ACExC 01.1 Profibus DP
85°
Damage at the change-over mechanism due to incorrect assembly!
Ò Only pivot the change-over lever manually.
Ò Using extensions as a lever for operation is not per
mitted.
Ò First engage manual operation correctly, then mount handwheel.
NOTICE