4. Select the interface card in the next window and confirm with Select.
➥
Now, the software searches for the EtherNet/IP module.
Information
Should the scan fail, either the Windows firewall or the antivirus software might have
to be deactivated.
5. Select the line with the respective module and open by clicking Configure.
6. Perform the selected settings and save using the Update Settings and Reboot
button.
Deactivated safety behaviour due to missing setting.
→
Ensure that the box in front of Modbus Polling With EIP Connection is ticked.
➥
If required, only the IP interface must be adapted to the requirements of the
network. All further settings of the EtherNet/IP module (in particular the serial
port settings) are set as default in the factory.
62
SA 07.2 – SA 16.2 / SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)
Commissioning (basic settings) AC 01.2 Non-Intrusive EtherNet/IP
To Next Page
Loading...
