auna TC-386WE - Phono to Tape Recording; CD;Phono;Cassette to MP3 Encoding

24
C. Recording from phono
• Select “Phono” function (6) and insert a blank cassette tape in deck 1 which suitable for recording.
• Press PAUSE rst and then “Record” & “Play“ key at cassette. Recording function is now stand by.
• Start the playback at phono and then press PAUSE on tape deck to start recording.
• To stop recording, press PAUSE and then “STOP/EJECT on tape deck rst, then return the tone
arm back to the rest station at phono.
Encoding of CD/phono or cassette tape to MP3 les
The system is able to encode audio from CD, record or tape to MP3 format and recording at memory media
to USB drive or SD card.
A) CD encoding
I) recording 1 track
• Play the CD track you want to encode/record, as normal.
• Press the “ Record “ button (3) during playback of the desired track. Corresponding symbols will
be ashing on the LCD display to show encoding is in progress.
• After the encoding process has nished, the unit will stop playback automatically.
II) Recording the complete CD
• Place a CD with the printed side facing up inside the CD tray & then close the cd door.
• After disc search has been completed, press the “Record “ button (3) – note: do not press „Play“
and then „Record“, or only the selected track will be recorded.
• Corresponding symbols will be ashing on the LCD display to show encoding is in progress.
• After the encoding process has nished, the unit will stop playback automatically
III) encoding by program
• Place a CD with the printed side facing up inside the tray & then close the co door
• Select the desire tracks by following “ CD disc programming “ procedures. Then press “CD Play/
pause/stop “ button (16) to start playback.
• Duying CD playback, press and hold the “ CD Play/pause/stop “ button (16) for 2 seconds to enter
the stop mode.
• Press the “ Record “ button (3) and the unit will display & & ashing. Encoding is performing now.
After completing of encoding, unit will stop playback automatically.
Remarks:
• The recording speed is 1:1 and according to the actual plying time of the CD/ phono or tape
• During copy mode, the system will copy the MP le only.
• The system will create a “ audio “ folder for encoding le and “ fcopy “ for copying le.
• The recording format is preset at – MP3 bit rate : 128 kbps, sampling rate : 44.1khz
• No song title will be recorded during encoding mode
• To interrupt the recording, press the “ Record “ button again during record mode.
• The system will store the le to USB source rst if both USB and SD slot are being occupied during
encoding.
• Copy MP3 le from USB/SD will be successful only entire song being copied, if terminate
the copying process intermediately, there is no track being recorded nor stored to the USB