Assembly instructions
1. Preparations
· Sauna package must be stored in a heated and dry room.
· Prior to installation ithe package must be opened and stored for 48h to adjust to
relative humidity of the room (22
o
C, 40-60% RH).
· Ensure the sauna model fits in the designated room with sufficient extra room for
ease of installation.
· Clean the location of sauna with care in order to not damage any details, elements
· Room must be well ventilated and with water drain on or near the position of the
sauna.
· Sauna is intended to be installed on a level surface to ensure proper installation and
quality of the installed product.
· Adequate electrical supply must be ensured for electrical components of the sauna.
Refer to user manuals of respective products.
· Electrical connections to the power grid and to the sauna may only be carried out by
legally competent and certified specialist.
· Producer cannot be held responsible for any errors resulting from disregard to the
levelness of substructure, inadequate storing conditions, inadequate power supply,
unauthorized alterations to components or any other circumstances occuring from
deviations described in this manual and/or good customs.
2. List of tools
· Water level
· Tape measure
· Power drill
· Rubber or plastic mallet
· Silicone gun
· Screwdriver set
Installation of a sauna requires at least two (2) persons.
3. Installations
· Follow the instructions precisely.
· Always start from 1 and continuosly move forward in an organized manner.
· Keep the installation site always clean and organized.
· This manual does not take into account any possible peculiarities of the installation
site.
· Take care not to damage any components during installation due to dropping,
dragging or careless handling.
· Special attention towards elements - they must be stored with care and kept away
from any hard or sharp objects. Glasses are tempered and even smallest damages
to the surface or corners can lead to concentration of stress and shattering of the
glass.
To Next Page
Loading...