AUTEC Air series - Page 11

LIIBKU00E1-02.fm 9 AUTEC - Air Series
A8 - Configuration Menu
Checking pairing
PAIR 2.0
Checking pairing
To make sure that the transmitting unit is paired with the desired receiving unit, start up the radio remote control and check
LED signals in the transmitting unit and the ENABLE LED signal in the receiving unit.
Transmitting unit Receiving unit PAIRING
The green LED blinks slowly. The ENABLE LED is off.
WRONG
The transmitting unit has been paired with an
undesired receiving unit because a wrong “SERI-
AL N.” has been saved.
This situation is highly dangerous, so immedi-
ately press the STOP pushbutton
a
.
a. If the transmitting unit is paired with a receiving unit that is not the desired one, do the following:
1 restore the receiving unit that has been paired by mistake: perform the UNPAIR (this procedure deletes the “SERIAL N.” that
has previously been saved); then perform the PAIR procedure with the transmitting unit that was originally paired with this
receiving unit;
2 finally perform the UNPAIR procedure and repeat the PAIR 2.0 procedure with the desired transmitting unit.
The green LED blinks.
The red LED is on.
The ENABLE LED is off.
FAILED
The transmitting unit has not been paired with any
receiving unit. You need to repeat the PAIR 2.0
procedure.
The green LED blinks slowly. The ENABLE LED blinks.
SUCCEEDED
The transmitting unit has been paired with the
desired receiving unit.