AUTEC Air series - Page 4

AUTEC - Air Series 2 LIIBKU00E1-02.fm
A8 - Configuration Menu
PAIR 2.0
In radio remote controls consisting of one transmitting unit and one receiving unit, when the transmitting unit cannot be used
any more it is possible to replace it with a back-up unit by performing the PAIR 2.0. procedure
The back-up transmitting unit is identical to the radio remote control's transmitting unit.
The back-up unit is marked with a label on the battery cover reading “BACK-UP UNIT”.
The PAIR 2.0 procedure is used to match a transmitting unit with a receiving unit.
The PAIR 2.0 procedure can only be performed if the radio remote control's transmitting unit cannot be used any
more (being broken, lost, damaged), that is to say, only in case of maintenance or replacement.
The PAIR 2.0 procedure can only be used for radio remote controls consisting of a transmitting unit and a receiving
unit.
This procedure cannot be used to share the control of a receiving unit among different transmitting units: if it is used
for that purpose, the machine where the radio remote control is used will result non-compliant (ref. IEC 60204-1 and
IEC 60204-32).
Depending on the application and on the working environment where the radio remote control works, a transmitting unit can
be paired with a receiving unit by performing one of these two procedures:
- PAIR 2.0 DIP: procedure that requires the opening of the receiving unit
- PAIR 2.0 SERIAL: procedure that implies entering the “SERIAL N.” and does not require the opening of the receiving unit.
BACK-UP UNIT
(with PAIR 2.0)