AUTEC Air series - GSS Pushbutton; EMS Pushbutton

LIUSK8B00_eng-01 AUTEC
22
8.3 GSS pushbutton
When the GSS pushbutton (if any) is activated, the Transmitting Unit
switches off and the Machine 󰘵ops. To 󰘵art the Radio Remote Control
again and enable it to control the Machine after the GSS pushbutton
has been pressed, you need to:
- Make sure that the working and usage conditions are safe.
- Pull or turn the GSS pushbutton in the arrow direction (shown on the
button) to unlock it.
- Start the Radio Remote Control following the procedure described in
paragraph 8.9).
The GSS pushbutton should be pressed when it is necessary to 󰄋op the
Machine immediately whenever a dangerous condition occurs.
The Machine Manufacturer and/or the In󰄋aller mu󰄋 provide the User with the
in󰄋ructions and warnings concerning possible risks that may originate from
the Machine 󰄋op (by way of example: movement inertia, swinging load…).
8.4 EMS pushbutton
When the EMS pushbutton (if any) is activated, the Transmitting Unit
switches off and the Machine 󰘵ops. To 󰘵art the Radio Remote Control
again and enable it to control the Machine after the EMS pushbutton
has been pressed, you need to:
- Make sure that the working and usage conditions are safe.
- Pull or turn the EMS pushbutton in the arrow direction (shown on the
button) to unlock it.
- Start the Radio Remote Control following the procedure described in
paragraph 8.9).
The EMS pushbutton should be pressed when it is necessary to 󰄋op the
Machine immediately whenever a dangerous condition occurs.
The Machine Manufacturer and/or the In󰄋aller mu󰄋 provide the User with the
in󰄋ructions and warnings concerning possible risks that may originate from
the Machine 󰄋op (by way of example: movement inertia, swinging load…).