AUTEC Air series - Staff training: installation and maintenance

LIUSK8B00_eng-01 AUTEC
26
8.9 Starting up the Radio Remote Control
Starting up the Radio Remote Control means enabling it to send commands and operate the
Machine.
The Radio Remote Control 󰄋art up is protected by a power keyswitch to
prevent unauthorised use of the Machine. If the risk assessment requires
further protection of the Radio Remote Control from unauthorized use, the
Machine Manufacturer and/or the In󰄋aller of the Radio Remote Control can
also enable a PIN code.
Autec will enable the PIN code for the Radio Remote Control 󰄋art up only
upon reque󰄋 by the Machine Manufacturer and/or the Radio Remote Control
In󰄋aller.
To activate the Radio Remote Control you need to insert the power keyswitch
and enter the PIN code (if applicable) following the procedure indicated in
paragraph 8.9.1 or 8.9.2.
The PIN code is not a sequence of numbers, but it consi󰘵s in the sequential activation of a
series of commands.
Commands activated while entering the PIN code are not sent to the Machine,
therefore they do not activate the corresponding Machine's movements and/or
functions.
8.9.1 Power keyswitch 󰄋art up (no PIN code)
When the Receiving Unit is powered on correctly, perform the following procedure:
1. Insert a fully charged battery in the Transmitting Unit (see paragraph 8.6.1).
2. Insert the power keyswitch in the Transmitting Unit.
3. Make sure that the GSS or EMS pushbutton is not pressed.
4. Activate START and hold it active until the green LED blinks fa󰘵.
5. Release START.
When the green LED blinks slowly, the Radio Remote Control is 󰘵arted.