AUTEC Air series - Data Feedback Function

LIUSK8B00_eng-01 AUTEC
30
8.14 Data Feedback Function
The User receives information and/or signals concerning some specific situations and the
movements of the controlled Machine by means of the Data Feedback function.
The Data Feedback function acts through the LED array and/or the display.
Any information shown and signalled on the display and/or through the LEDs
for Data Feedback function can never be considered or used as a safety signal
or for legal metrology.
When operating the Machine, remember that the Radio Remote Control does
not cut in autonomously when potential hazardous situations are shown and
signalled.
If the green LED repeats the sequence "three blinks and a pause", no
information and/or signals related to the Data Feedback function is shown
via the LEDs and/or display. The Transmitting Unit may however be able to
send commands (if activated) to the Receiving Unit and activate movements
on the Machine. In this case, bring the Transmitting Unit closer to the Receiving
Unit until the green LED blinks slowly.
During normal Radio Remote Control operation, pay particular attention to the indications
displayed and signalled by the display and/or through the LEDs: they can be helpful to evaluate
the Machine working 󰘵atus.
Operation with display
If the Transmitting Unit has a display, it is possible to show warning icons, the measurements
collected from the Machine and their description.
The Machine Manufacturer chooses which information are displayed and the way they are
displayed (icons and/or measurements and/or descriptions).
In addition, the battery level and the quality of the radio link are always indicated.
Operation with LED
If the Transmitting Unit has an LED array for the Data Feedback function, specific Machine
conditions are signalled if they are illuminated (by way of example: load limits, limit switch).
The signalled conditions depend on the settings chosen by the Machine Manufacturer.