Optional Functions
1.
The Operate interface available
Add another Operate button to open or close the door.
2.
The photo beam interface available
When connecting pulsed quantity control infrared sensor, wiring as per Fig.12. When infrared
sensor is
controlled by switch value, wiring as per Fig.13. Notice: Close the photo beam
function when you don’t use
photo beam sensors.
3.
Flash light function (optional)
There are corresponding interfaces for this function and provide 24v-35v flash light
voltage. Connect the
flash light with DC 24v-28v, current≤100mA. When using flash lights off 220V AC, please match an adapter,
and wiring as required(Fig.14).
4.
Pass door (SD) protection (optional)
This function ensure that the door can’t be opened unless the small pass door is closed.
The door panel won’t
be damaged. Connect according to Fig.15 .
Fig. 12
To Next Page
Loading...