Fig. 10
Fig. 11
1.
As per Fig.7, slide the end rail into the 1st sleeve & slide the middle rail into the 1st sleeve.
2.
As per Fig.8, slide the 2nd sleeve to the other end of middle rail & slide the top rail into the 2nd
sleeve.
3.
Remove the plastic film on the end rail , cut the plastic cable tie on the screw rod ”A”.
4.
As per Fig.9, pull the screw rod ”A” along with inner chain to the end of top rail.
5.
As per Fig.10, undo the nut & spring.
6.
Tighten the nut to the right position as shown in Fig.11 and cut the plastic cable tie on sprocket.
The rail is now assembled and read
for installation.
To Next Page
Loading...