1-1
Welcome.
Congratulations on your purchase of an Auto-
Sleeper motorhome. We are confident it will
give you many years of pleasure.
This handbook has been compiled to enable
you to obtain the maximum pleasure from
your vehicle. It contains the appliance
instructions along with advice on safety
matters.
Please read this Handbook thoroughly so that
you are conversant with all the motorhome
systems, operating instructions and
precautions.
Failure to observe these recommendations or
precautions may result in incorrect operation
of equipment and subsequent risk to
occupants.
Information leaflets and literature on safe
operation of appliances and equipment fitted
to your motorhome are included in the Auto-
Sleeper Customer Pack. Please read these
carefully prior to use.
Should you experience any difficulties contact
your dealer who will be pleased to offer
advise.
It is the policy of Peugeot and Auto-Sleeper to
continually improve their vehicles, so whilst
the details contained in this Handbook are
correct at the time of going to press, they
reserve the right to alter the specifications at
any time without notice.
Auto-Sleeper motorhomes offer a variety of
customer uses and whilst each vehicle
features the optimum storage, fluid, seating
and sleeping capabilities, it is the customer’s
responsibility to select the proper
combinations of loads without exceeding
weight capacities.
Your Auto-Sleeper motorhome conforms to
the European standard of EN 1646.
Model
This Handbook covers all versions of the
Lancashire, based on the Peugeot L1 short
wheelbase chassis cab.
The Lancashire EK and EL models have an
MTPLM of 3300 kg, whilst the ES version has
an MTPLM of 3500 kg to allow for the extra
passengers.
Gas System
This handbook is for use on vehicles with a
30mbar gas system. The gas system
pressure is noted on a label in the gas locker.
Conversion Type
A coachbuilt conversion, the Lancashire has
two berths and the ES version has four.
Laminated panel and glass-fibre combination.
Insulated panels have GRP outer skin.
Climatic Conditions
The motorhome is designed for use in
temperate climates, and has insulation
levels to Grade 3 in accordance with
EN 1646-1:2004.
Handbook
Any queries should be addressed to your
Auto-Sleeper dealer.
Appliance Instructions
The appliance instructions included have
been extracted from those supplied from the
appliance manufacturers.
Automotive - Peugeot
For all automotive matters you should refer to
the Peugeot vehicle instructions manual. This
includes tyre pressures, referring to the type
of tyres fitted.
The Auto-Sleeper conversion does not affect
the tyre pressures in any way as it is built
within the design envelope of the base
vehicle.
IMPORTANT:
In the interests of safety, replacements parts
for appliances must conform to the
manufacturer’s specification and should be
fitted by them or an authorised agent.
Your Auto-Sleeper conforms to the CEN
INTRODUCTION
To Next Page
Loading...