Chapter 5: DURAPULSE MODBUS Communications
5–8
Display Parameters
P8.00
User Defined Display Function 0800 42049 4000
P8.01
Frequency Scale Factor 0801 42050 4001
P8.02
Backlight Timer 0802 42051 4002
* For Modbus Decimal addresses used with CLICK PLCs,
insert another zero as the next-to-most-significant digit, e.g., 402333 instead of 42333.
** Some parameters are available only in later firmware versions of DURAPULSE drives.
Refer to P9.39 and “DURA
PULSE Parameter Summary” in Chapter 4 for more information.
Parameter can be set during RUN Mode.
Parameter Memory Addresses (continued)
Parameter Description Hexadecimal
Modbus
Decimal *
Octal
PID Parameters
P7.00
Input Terminal for PID Feedback 0700 41793 3400
P7.01
PV 100% Value 0701 41794 3401
P7.02
PID Setpoint Source 0702 41795 3402
P7.03
PID Feedback Gain 0703 41796 3403
P7.04
PID Setpoint Offset Polarity 0704 41797 3404
P7.05
PID Setpoint Offset 0705 41798 3405
P7.06
PID Setpoint Gain 0706 41799 3406
P7.10
Keypad & Serial PID Setpoint 070A 41803 3412
P7.11
PID Multi-setpoint 1 070B 41804 3413
P7.12
PID Multi-setpoint 2 070C 41805 3414
P7.13
PID Multi-setpoint 3 070D 41806 3415
P7.14
PID Multi-setpoint 4 070E 41807 3416
P7.15
PID Multi-setpoint 5 070F 41808 3417
P7.16
PID Multi-setpoint 6 0710 41809 3420
P7.17
PID Multi-setpoint 7 0711 41810 3421
P7.20
Proportional Control 0714 41813 3424
P7.21
Integral Control 0715 41814 3425
P7.22
Derivative Control 0716 41815 3426
P7.23
Upper Bound for Integral Control 0717 41816 3427
P7.24
Derivative Filter Time Constant 0718 41817 3430
P7.25
PID Output Frequency Limit 0719 41818 3431
P7.26
Feedback Signal Detection Time 071A 41819 3432
P7.27
PID Feedback Loss 071B 41820 3433
P7.28**
PID Feedback Loss Preset Speed 071C 41821 3434
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013
To Next Page
Loading...