AutomationDirect DURAPULSE GS3-4030 - Page 79

4–11
Parameter Summary (continued)
Parameter
*
Description Range*
Default
Setting
User
Setting
PID Parameters
P7.00
Input Terminal
for PID Feedback
00: Inhibit PID operation
01: Forward-acting (heating loop) PID
feedback, PV from AI1 (0 to + 10V)
02: Forward-acting (heating loop) PID
feedback, PV from AI2 (4 to 20 mA)
03: Reverse-acting (cooling loop) PID
feedback, PV from AI1 (0 to +10V)
04: Reverse-acting (cooling loop) PID
feedback, PV from AI2 (4 to 20 mA)
00
P7.01
PV 100% Value 0.0 to 999 100.0
P7.02
PID Setpoint Source
00: Keypad
01: Serial Communications
02: AI1 (0 to +10V)
03: AI2 (4 to 20mA)
02
 P7.03
PID Feedback Gain 00 to 300.0% 100
 P7.04
PID Setpoint Offset Polarity
00: No Offset
01: Positive Offset
02: Negative Offset
00
 P7.05
PID Setpoint Offset 0.0 to 100.0% 0.0
 P7.06
PID Setpoint Gain 0.0 to 300.0% 100
 P7.10
Keypad PID Setpoint 0.0 to 999 0.0
 P7.11
PID Multi-setpoint 1 0.0 to 999 0.0
 P7.12
PID Multi-setpoint 2 0.0 to 999 0.0
 P7.13
PID Multi-setpoint 3 0.0 to 999 0.0
 P7.14
PID Multi-setpoint 4 0.0 to 999 0.0
 P7.15
PID Multi-setpoint 5 0.0 to 999 0.0
 P7.16
PID Multi-setpoint 6 0.0 to 999 0.0
 P7.17
PID Multi-setpoint 7 0.0 to 999 0.0
 P7.20
Proportional Control 0.0 to 10.0 1.0
 P7.21
Integral Control 0.00 to 100.0 sec 1.00
 P7.22
Derivative Control 0.00 to 1.00 sec 0.00
P7.23
Upper Bound for Integral Control 00 to 100% 100
P7.24
Derivative Filter Time Constant 0.0 to 2.5 sec 0.0
P7.25
PID Output Frequency Limit 00 to 110% 100
P7.26
Feedback Signal Detection Time 0.0 to 3600 sec. 60
P7.27
PID Feedback Loss
00: Warn and AC Drive Stop
01: Warn and continue operation
02: Warn and continue at last frequency
03: Warn and continue
at Preset Speed (P7.28)
00
 P7.28
PID Feedback Loss Preset Speed 0.0 to 400.0 Hz 0.0
* Some parameters and settings are available only in later firmware versions of DURAPULSE drives. Refer to
the beginning of this “DURA
PULSE Parameter Summary” section for more information.
 Parameter can be set during RUN Mode.
Chapter 4: AC Drive Parameters
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013