AutomationDirect DURAPULSE Series - Page 157

5–7
Parameter Memory Addresses (continued)
Parameter Description Hexadecimal
Modbus
Decimal *
Octal
Protection Parameters
P6.00
Electronic Thermal Overload Relay 0600 41537 3000
P6.01
Auto Restart after Fault 0601 41538 3001
P6.02
Momentary Power Loss 0602 41539 3002
P6.03
Reverse Operation Inhibit 0603 41540 3003
P6.04
Auto Voltage Regulation 0604 41541 3004
P6.05
Over-Voltage Stall Protection 0605 41542 3005
P6.06
Auto Adjustable Accel/Decel 0606 41543 3006
P6.07
Over-Torque Detection Mode 0607 41544 3007
P6.08
Over-Torque Detection Level 0608 41545 3010
P6.09
Over-Torque Detection Time 0609 41546 3011
P6.10
Over-Current Stall Prevention during Acceleration 060A 41547 3012
P6.11
Over-Current Stall Prevention during Operation 060B 41548 3013
P6.12
Maximum Allowable Power Loss Time 060C 41549 3014
P6.13
Base-Block Time for Speed Search 060D 41550 3015
P6.14
Maximum Speed Search Current Level 060E 41551 3016
P6.15
Upper Bound of Output Frequency 060F 41552 3017
P6.16
Lower Bound of Output Frequency 0610 41553 3020
P6.17
Over-Voltage Stall Prevention Level 0611 41554 3021
P6.18
Braking Voltage Level 0612 41555 3022
P6.30**
Line Start Lockout 061E 41567 3036
P6.31
Present Fault Record 061F 41568 3037
P6.32
Second Most Recent Fault Record 0620 41569 3040
P6.33
Third Most Recent Fault Record 0621 41570 3041
P6.34
Fourth Most Recent Fault Record 0622 41571 3042
P6.35
Fifth Most Recent Fault Record 0623 41572 3043
P6.36
Sixth Most Recent Fault Record 0624 41573 3044
 P6.37**
Hunting Gain 0625 41574 3045
* For Modbus Decimal addresses used with CLICK PLCs,
insert another zero as the next-to-most-significant digit, e.g., 402333 instead of 42333.
** Some parameters are available only in later firmware versions of DURAPULSE drives.
Refer to P9.39 and “DURA
PULSE Parameter Summary” in Chapter 4 for more information.
 Parameter can be set during RUN Mode.
Chapter 5: DURAPULSE MODBUS Communications
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013