AutomationDirect DURAPULSE Series - Page 211

5–61
DL RX/WX Communication Program (continued)
(Continued next page)
27
Drive #2 Fault Indication
Reset
X21
28
()
SET
Drive #2 Fault
C31
()
RST
Drive #2 Fault
C31
*** The following 21 rungs (27–47) are for slave 2 communications control. ***
V2020
욷
K1
29
Drive #2 Overload Indication
Reset
X22
30
()
SET
Drive #2 OL
C32
()
RST
Drive #2 OL
C32
V2020
=
K4
31
Drive #2
Direction New
V3022
=
Drive #2
Direction Retain
V3032
Drive #2
External Fault New
V3023
=
Drive #2
External Fault Retain
V3033
Drive #2
Fault Reset New
V3024
=
Drive #2
Fault Reset Retain
V3034
Drive #2
Speed Ref New
V3020
=
Drive #2
Speed Ref Retain
V3030
()
SET
Drive #2
Speed Ref
Write Enable
C40
Drive #2 Speed Ref
Write Enable
C40
Drive #2
Run CMD
Write Enable
C42
This rung turns on C31 if there is a fault in drive #2.
This rung allows a switch on input X21 to reset the C bit used to indicate drive #2 fault.
This rung turns on C32 if drive #2 has an overload fault.
This rung allows a switch on input X22 to reset the overload fault bit C32.
This rung checks to see if the drive Speed, Direction, External Fault, or Fault Reset
conditions have been changed in the local program, and need to be written to drive #2.
Chapter 5: DURAPULSE MODBUS Communications
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013