AutomationDirect DURAPULSE Series - Page 312

Index
i–6
(P – continued)
Parameters - Summary: 4–2
Analog Parameters: 4–7
Communications Parameters: 4–12
Digital Parameters: 4–5
Display Parameters: 4–12
Encoder Feedback Parameters: 4–14
Motor Parameters: 4–2
PID Parameters: 4–11
Presets Parameters: 4–8
Protection Parameters: 4–9
Ramp Parameters: 4–3
Volts/Hertz Parameters: 4–4
Parameters available in firmware versions: 4–2
PID Disable: 4–30, 4–35
PID Parameters: 4–66
PID Setpoint Bits: 4–30, 4–32
PLC - compatible ADC PLC modules: B–2
PLC - connections to ADC PLC modules: B–8
PLC, GS3 communicate with ADC: 5–14
CLICK Modbus Programming: 5–23
DirectLOGIC Modbus Programming: 5–38
Power Circuit Terminals: 2–13
Power Supply: 2–23
Power Wiring Diagrams: 2–18
Programming the AC Drive: 3–5
Q
Quickstart: 3–6
R
Reactor: 2–23
Reactors, Line: A–2
Wiring Connections: A–17
Recharge capacitors: 6–2
Remote Panel Adapter: A–49
Reset Speed to Zero: 4–30, 4–35
Resistor - braking: 2–23
Revision History of User Manual: h–1
RF Filter: A–37
S
Safety Codes: w–1, 2–12
Canadian Electrical Code (CEC): 2–12
cUL: 2–12
National Electrical Code (NEC): w–1, 2–12
National Electrical Manufacturers Association
(NEMA): w–1
National Fire Code: w–1
UL: 2–11, 2–12
Safety Information: w–1, w–3
Second Accel/Decel Time: 4–30, 4–33
Serial Communication Port: 1–6, 4–76, 5–14,
5–67
Short Circuit Withstand: 1–7, 2–12
Software, Configuration: A–47
Source Select: 4–30, 4–35
Special Symbols: 1–2
Notes: 1–2
Warnings: 1–2
Specifications
Control Circuit Terminals: 2–20
Main Circuit Wiring Terminals: 2–17
Specifications, GS3 AC Drives: 1–7
Speed Hold: 4–30, 4–34
Status Addresses: 5–11
Status Monitor: 5–11
Status of the Drive - Keypad Display: 3–4
Storage Conditions: 2–2
Supplemental Publications: 1–2
National Electrical Manufacturers Association
(NEMA): 1–2
T
Table of Contents: c–1
Technical Support: 1–2
Terminal Diagrams: 2–13
Trademarks: w–1
Troubleshooting: 6–3
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013