LED blue: io-link communication
1 3
2 4
In conjunction with a prismatic reector or reective tape the retro-reective sensor detects objects and materials without contact and indicates
their presence by a switching signal.
► The unit must be connected by a qualified electrician.
► Disconnect power.
► Connect the unit as follows:
INTENDED USE
OPERATING AND DISPLAY ELEMENTS
ELECTRICAL CONNECTION
INSTALLATION
SAFETY INSTRUCTIONS
AUTOMATION & SENSORS
autosen AO044
Retro-reflective sensor
Further technical details as well as suitable accessories
are indicated in a detailed data sheet.
Visit www.autosen.com or scan the QR code.
UK
autosen gmbh | Annastraße 41 | 45130 Essen
► The product must be suitable for the corresponding applications and environmental conditions without any restrictions.
► Only use the product for its intended purpose (-> Intended use).
► If the operating instructions or the technical data are not adhered to, personal injury and/or damage to property may occur.
► The manufacturer assumes no liability or warranty for any consequences caused by tampering with the product or incorrect use by the operator.
► Installation, electrical connection, set-up, operation and maintenance of the product must be carried out by qualified personnel authorised by the
machine operator.
► Protect units and cables against damage.
LED yellow: switching output active
LED green: operation, stability indication
Teach button
L-
L
+
1
3
4
OUT2
OUT1/IO-Link
2
BU
BN
WH
BK
► Place the triple mirror or reflective tape behind the object to be detected.
► Align the reflective sensor on it and fix it with the help of a mounting bracket.
Maximum range only with precise alignment.
To Next Page
Need help?
General
