Need help?Do you have a question about the Autotek Super Sport SS75.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 75W x 2 |
| RMS Power at 2 Ohms | 100W x 2 |
| Bridged RMS Power at 4 Ohms | 200W x 1 |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| THD at Rated RMS Power | <0.05% |
| Low Pass Filter | Yes |
| High Pass Filter | Yes |
| Bass Boost Frequency | 45Hz |
| Frequency Response | 10Hz |
| Bass Boost | 0dB |
Covers model capabilities, tri-mode operation, protection systems, and diagnostic features.
Details the X-Over switch functions and illustrates control panel layouts for different amplifier models.
Describes the most basic application for 2-channel amplifiers in full range stereo mode.
Illustrates the basic mono bridging method for 2-channel amplifiers.
Details setting up a 2-channel amplifier for high frequencies and a second for low frequencies or mono subwoofer.
Shows how to use 4-channel amplifiers as discrete 4-channel full range units.
Demonstrates using 4-channel amps in 2 or 3-channel mode via mono bridging.
Explains implementing a 2-way system using a 4-channel amp for highs and bass.
Details a 2-way system using front outputs for highs and rear outputs for bass, allowing level adjustment.
Details the basic setup for sub bass amplifiers using bi-amplification systems.
Illustrates connecting parallel mono subwoofers to the 1-channel amplifier for 2-Ohm operation.
Covers initial system power-up, control settings, and detailed level adjustment procedures for various system types.
Guidelines for fine-tuning crossover frequencies and equalizer settings for optimal sound balance.
Covers troubleshooting no power, no sound, channel issues, and no bass/stereo sound.
Addresses speaker distortion, amplifier protect mode activation, and potential causes.
Guides on resolving electrical interference and speaker noise, including cabling and source unit checks.
To Next Page
